This modification adds LEDs to the facelift Xenon globes, allowing you to use them for DRLs or just for show. Rather than requiring you to bond each single LED to each part of the globe, this kit features LED "carriers", 3D printed in the same material as the headlight internals, ensuring the LEDs are in the exact position.
To install these, your lights must be dis-assembled (as you would when "Joey modding" your lights), and a single hole drilled at the rear of the headlights to pass the power cable through. The carriers are then bonded in place, and the LEDs wired in.
We offering 4 options for this kit, depending on the options required, and if you would prefer to self-assemble the kit or to have the kit pre-assembled - self-assembly requires 2mm x 3mm PCB pads to be soldered, so please ensure you have the required solder and soldering iron, and approx 1-2 hours soldering time.
Full instructions will be supplied.
Please be aware that headlights are not included.
Option 1 - RF controller and self-assembly
Option 2 - RF controller and pre-assembled
Option 3 - Bluetooth controller and self-assembly
Option 4 - Bluetooth controller and pre-assembled